have a bizhub c 6501 fitted with a fiery.once the machine finishes printing one job the controller tab(option on the display becomes inactive) goes off untill the machine is restarted.
any idea
thanks
any idea
thanks
-
-
which firey? if 408 ds 2-1 must be set to onComment
-
I would start as stated above. Otherwise:
Switch off the controller and the printer on the mains.
Remove and re-install the SCSI cable between them. Sometimes the connection isn't mechanically sound.
The interface boards can also be out of sync, and require replacing, but this usually gives more random faults, yours is repeatable.Comment
-
bizhub pro c6501
have connected the faulty fiery to another machine behaves the same.memory or hard disk suspect.any reset cure for this problemComment
-
Have you looked to see if there is a firmware update for this? Or a patch for the fiery?Color is not 4 times harder... it's 65,000 times harder.
They call it "TECH MODE" for a reason. I have manual's and firmware for ya, course... you are going to have to earn it.Comment
-
what options are on the machineComment
Comment