View Full Version : Error Code kYOCERA 4050 , SC 7410
pinspin
02-28-2013, 05:09 PM
Hello. I installed the repair kit MK-715 in Kyocera 4050. After switching on the copier shows code SC 7410. It turned out that the machine had drum unit DK - 716 installed, and the repair kit had a drum unit DK - 715 . Can I use the drum unit DK - 715 instead of the drum unit DK - 716? If so, what do i need to do? thanks
kkendric
02-28-2013, 06:58 PM
DK715 used in KM-3050 only
DK716 used in KM4050 and K5050 only
blackcat4866
03-01-2013, 01:31 AM
DK715 used in KM-3050 only
DK716 used in KM4050 and K5050 only
Correct. If I remember correctly the drum itself is the same, the difference is with the chip and the drum cleaning lamps. If you insert the new drum into the old unit it will work, but you'll still be stuck with the maintenance indication. =^..^=
pinspin
03-01-2013, 08:18 AM
DK715 used in KM-3050 only
DK716 used in KM4050 and K5050 only
thanks
pinspin
03-01-2013, 08:19 AM
Correct. If I remember correctly the drum itself is the same, the difference is with the chip and the drum cleaning lamps. If you insert the new drum into the old unit it will work, but you'll still be stuck with the maintenance indication. =^..^=
thanks , I will try to change
cysec
04-03-2014, 02:17 PM
Another option I have had success with us to swap the connector board at the back of the drum unit. Though I wouldn't advise doing this if you are trying to put a 3050 unit into a 4050 or 5050 as the CQ will likely decline rather quickly.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.