If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Pls. help on Bizhub 350 output copy is a little oblique/slanted...how to fix?
Re: Pls. help on Bizhub 350 output copy is a little oblique/slanted...how to fix?
So ... is it an optical skew from a print, an optical skew from a copy, or a paper skew? =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
Re: Pls. help on Bizhub 350 output copy is a little oblique/slanted...how to fix?
THIS IS YOUR FIX... Remove glass and use a hex wrench (maybe 1.5mm? or 1.27?) on front and/or rear black hex screws that have threadlock on them in the CCD/lens box. Twist 1/4 turn cw or ccw and note the change. test, correct as needed. If you go too far, you will see black ribs on edges. Anytime these are rolled around and strongly vibrated, we notice optic skew, even when adjusted correctly, then delivered to customer a bounce on the sidewalk or worse yet, concrete with cobblestone is sure to do it, so be careful when moving! This is a standard part of our refurb process.
Re: Pls. help on Bizhub 350 output copy is a little oblique/slanted...how to fix?
it is a skew from a print out but my original is perfectly fine...and I notice if I do a tests pattern copy the turn out is fine and not skew...only when i copy a fine one the output is skew... thanks for all your help guys
Re: Pls. help on Bizhub 350 output copy is a little oblique/slanted...how to fix?
Yank up the left front corner of the scanner unit. Somebody was leaning on it and it went down a little.
This is the most common cause of skewing in the copy mode by all machines of this design starting with the Di-350 through Di-351, Di-3510 series until the BH-350's and likely also the BH-362 series.
Re: Pls. help on Bizhub 350 output copy is a little oblique/slanted...how to fix?
Hansoon tnx it really works Yanking up the left front corner of the scanner unit, now the output copy is A okey no more skew tnx again...your the man...
Comment