Thanks: 
Likes: That is still considered fraud in most countries. Jail time can vary.Originally Posted by vinhsesco
Dislikes: 0
That is still considered fraud in most countries. Jail time can vary.
have you:
replaced ALL consumables?
rebuilt/replaced all feed/sensors/transport/exit/adf assemblies?
thoroughly clean ALL covers/metal/plastic parts?
(nope I guarantee you haven't_
if you haven't you are running a scam!
here's a better way....
Do the major parts of my questions. supplies=pm parts=feed/transport rollers
leave the counters alone (you'll mess up PM cycles)
take a start page/usage pages.. note counts on rental contract (you do have one )
deliver it .. telling customer what has been done to cover past page counts to bring it up to rental standards.
set the supply/PM notices to come to your company.
do the damn PM's on time and do not HALF ASS the PM's.
you look like a more honest service group
and word of MOUTH is the BEST/worse advertisement you can ever have.
Be straight with people .. or it could come back around and bite your ASS OFF! ( I worked for a FUCKER like you seem to be.. he was only in business for 5 years.. still has 5 years in FEDERAL prison for fucking over the NCAG on a "Compaq Server" that had ALL clone parts in it!) *not even the RAM he used was Compaq*
but be the shit you want to be.. but do not expect any more help/advise from me ..ever.. but you can expect more red cards from me if I see you asking these same type help in the future!
reminds me of matilda,when Danny Devito is using the drill to reset the counter
I will talk to customers. I thank all of you very much
hello, what you should do is change the NV RAM. This sets the counter to zero. The firmware only updates the device. If you rent the equipment it is obvious that it has a previous use and deals with the client. If you want to pass the equipment as new, it is fraud. rent new equipment
i have a easier way for you to get counter to 0
turn machine upside down and print.
your counter will then go backwards.
there is the possibility to reset the counters
I know how to do it, but.... I don’t say!
I am possible.
Write the F_RAM installation program to the counter board using the jig, put it in the machine, and enter the service mode. Clear MMI OK The total counter becomes "0".
I am possible.
maybe in YOUR country but in alot of the world IT IS ILLEGAL!
[QUOTE = 필 B.; 1052826] 가능합니다.
어쩌면 당신의 나라에 있지만 세계의 많은 곳에서 IT는 불법입니다! [/ QUOTE]
When you buy a new counter board from Canon, you have data on the new board.
Post-installation manuals are also included.
Reply With Quote
Bookmarks