Looking for help, a very thin white line appeared during the KM1250p

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • ecstaszyzhang
    Junior Member
    • May 2021
    • 3
    #1

    [Misc] Looking for help, a very thin white line appeared during the KM1250p

    Looking for help, a very thin white line appeared during the KM1250p printing process. Replacing the charging stand, laser, and photosensitive drum did not solve the problem.不好的.jpg
    Looking for help, a very thin white line appeared during the KM1250p printing process. Replacing the charging stand, laser, and photosensitive drum did not solve the problem.
    Tags: appeared, km1250p, line, thin, white
    • blackcat4866
      Master Of The Obvious

      Site Contributor
      10,000+ Posts
      • Jul 2007
      • 22662
      #2
      Re: Looking for help, a very thin white line appeared during the KM1250p

      KM-1250P never had a laser, so you could not have changed it, but you might have changed the LED Array which serves a similar purpose.

      If a charging stand is a primary charge corona unit, then yes, that might help. Changing the drum might have helped too.

      How about developing? Is there a recognizable pattern on the developing roller? It could be as simple as some fuzz hanging from the drum blade, the developer seal, or the doctor blade. =^..^=
      If you'd like a serious answer to your request:
      1) demonstrate that you've read the manual
      2) demonstrate that you made some attempt to fix it.
      3) if you're going to ask about jams include the jam code.
      4) if you're going to ask about an error code include the error code.
      5) You are the person onsite. Only you can make observations.

      blackcat: Master Of The Obvious =^..^=

        Comment

        • allan
          RTFM!!

          5,000+ Posts
          • Apr 2010
          • 5445
          #3
          Re: Looking for help, a very thin white line appeared during the KM1250p

          Looks a lot like failed LPH elements. Take a picture of your "laser"...
          Does the transfer belt have deep scratches in it?
          Whatever

            Comment

            • Markks
              Senior Tech

              Site Contributor
              VIP Subscriber
              500+ Posts
              • Feb 2018
              • 502
              #4
              Re: Looking for help, a very thin white line appeared during the KM1250p

              I would start by reseating all the harnesses from the board in the back of machine to the LPH

              I've seen the cables going to the LPH to the first interface board cause this problem. I have also had to replace the interface board that the LPH plugs into for this problem.

                Comment

                • slimslob
                  Retired

                  Site Contributor
                  25,000+ Posts
                  • May 2013
                  • 34940
                  #5
                  Re: Looking for help, a very thin white line appeared during the KM1250p

                  I find it interesting that the only in grey scale and not across solid black. And it is not just in the one side of the grey scale picture. Zooming in it is also present in the other half if the picture and the grey scale bars but closer together. It looks like it is superimposing an inverted dot line test pattern on the Test Page. You may have bad memory, HDD that needs reformatting or bad IPU(Ricoh term), Image Processing Unit, or controller.

                    Comment

                    Previous template Next
                    Working...