Thanks: 
Likes: 
Dislikes: Thank you and please, please do. I would need the video instruction.
Thank you and please, please do. I would need the video instruction.
If you could point out in instruction which parts to look for to see the damage and check if it is bad before I order replacement. Thank you!
The paper size is not a problem. There is A4 <> Letter paper substitution set up in settings.
Is this the video? YouTube
Not the video but I will post one this weekend.Originally Posted by kurbads
Sent from my SM-T530NU using Tapatalk
The correct piece to order is the entire pre-heat assembly. Just trying to replace bits and pieces of it is hopeless. Once the nylon gears start to shred they all go.
Sent from my SM-T530NU using Tapatalk
I ordered one. A used one from the listing you quoted. Can you advice how many warmups does it survive? Could it be what contributed to its premature death the fact that printer was resetting itself at midnight and reheating inks every day?
How many sheets on the unit you have? They tend to get brittle gears and stance shutter at 750,000 copies. Sometimes you just have bad luck and they let go sooner. I will point out in the vid what to check for.
The resets at midnight wouldn't cause this piece to fail. It dies due to copies and age.
Sent from my SM-T530NU using Tapatalk
If you look at 89-520 in the service manual figure 2. That sensor cap that the arrow points to always de-bonds from the shaft. Once it has let go your finished.
Sent from my SM-T530NU using Tapatalk
I'm running behind. Will post the video later this week....
Posting Permissions
Reply With Quote
Bookmarks