Thanks Thanks:  0
Dislikes Dislikes:  0
Results 1 to 7 of 7

Thread: Xerox C75

  1. #1
    Technician
    Join Date
    Feb 2008
    Location
    Canton
    Posts
    26
    Rep Power
    26

    Xerox C75

    Continuing saga again 061-340 code, replaced c,k ros unit same thing again. Flat cables maybe? Interlock switch seems to be ok.

  2. #2
    Technician
    Join Date
    Feb 2008
    Location
    Canton
    Posts
    26
    Rep Power
    26

    Re: Xerox C75

    Itís showing the 061-319 code also....

  3. #3
    Senior Tech 250+ Posts InterfaceP's Avatar
    Join Date
    Jun 2013
    Location
    TX
    Posts
    467
    Rep Power
    20

    Re: Xerox C75

    Try replacing the K Drum first, but while you have it out check to see if the earth pad is there. Its a small pad to the rear and left. It should be visible when you remove the drum.

  4. #4
    Technician
    Join Date
    Feb 2008
    Location
    Canton
    Posts
    26
    Rep Power
    26

    Re: Xerox C75

    Quote Originally Posted by InterfaceP View Post
    Try replacing the K Drum first, but while you have it out check to see if the earth pad is there. Its a small pad to the rear and left. It should be visible when you remove the drum.
    Put a new one in, cleaned the pad also

  5. #5
    Senior Tech 100+ Posts
    Join Date
    Feb 2010
    Posts
    174
    Rep Power
    23

    Re: Xerox C75

    Flat cables are usually the problem, plus they are super tricky to re-attach as well. MCU PWB would be next up.

  6. #6
    Technician EAHG's Avatar
    Join Date
    Jan 2020
    Location
    Suva
    Posts
    17
    Rep Power
    1

    Re: Xerox C75

    Flat Cables. make sure its seated properly after replacing and take extra caution when returning it back as the flat cables easily comes off or loose contact when repositioning, its very tricky.

  7. #7
    Trusted Tech 50+ Posts elsab's Avatar
    Join Date
    Dec 2007
    Posts
    59
    Rep Power
    26

    Re: Xerox C75

    Quote Originally Posted by EAHG View Post
    Flat Cables. make sure its seated properly after replacing and take extra caution when returning it back as the flat cables easily comes off or loose contact when repositioning, its very tricky.
    Might be a problem with front cover interlock or with Xero/Deve Drawer assy connector loose contact. It happens on to previous model similar engine with C75.

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here