ir3570 persistent jam on PS10

[Guest]

Re: ir3570 persistent jam on PS10

My IR 3045 Do the same
the Paper stops in the middle of the fixing unit. when i removed the paper it is folded like an accordion.

I tried all 4 trays and did the same thing
Paper Orientation: Portait

I did notice that when i place the paper in Landscape it works much better but will jam after couple of copies and some of the copies have fold in the middle. so it goes out of the machine shorter than other copies.
Error: 1017, 0202, 0102, 0201

All sensors checked, - not sticking
right door flapper check
Fixing unit rolls fine

Paper: SUB20/70gsm

[copier tech]

Re: ir3570 persistent jam on PS10

Ok, does the machine have a Genuine Canon Fixing Film Assy fitted?

[Guest]

Re: ir3570 persistent jam on PS10

i got my issue fixed by cleaning the solenoid:
There's a worn foam that turns sticky and delays paper out.

[doc1479]

Re: ir3570 persistent jam on PS10

Well, as it turned out, it was registration actuator related after all.

I have put new one in, but that by itself wasn't enough, I had to bend bracket a bit to bring it forward and it went through without a hitch after that. Both A4 and A4R ran fine on single or duplex.

Thanks guys for your help !

[Guest]

Re: ir3570 persistent jam on PS10

any instructions on how to change the Ps9 or pre registration sensor?

[copier tech]

Re: ir3570 persistent jam on PS10

If you take out the top feed unit you can gain access from underneath

[mpj]

Re: ir3570 persistent jam on PS10

Hi everybody,

I hope somebody can help me here, as I'm running out of ideas.

I have an issue on ir3570. It constantly jams 0101 on ps10, either stationary or delay.
Paper is always stuck half way through the fuser.

Unit already got gray vertical path rollers (FB6-4852) and upgraded lower door assy (FM3-1296).

I've put new registration sensors (FL2-6580) and swapped pickup assemblies around. I've also removed dumper on ps9 and cleaned the sensors. Same story.

It prints/copies fine from manual feed, so I've ruled out any fuser related issues.

It has old style preregistration flag, no metal jacket, but hardly any wear (15mm), so I don't think it needs a replace.

Any thoughts ?

Thanks,
John

hi john
remove the black sponges on the paper deliver guide on the right door.when they get old the guide stucks all the time.

[sa0001jan]

where is ps9 sensor in canon machine please tell me

where is ps9 sensor in canon machine please tell me

[copier tech]

Re: where is ps9 sensor in canon machine please tell me

where is ps9 sensor in canon machine please tell me

Refer to the parts/service manual