IRadvc5030 - not booting

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • teckat
    replied
    Re: IRadvc5030 - not booting

    Originally posted by MunsterTech
    hi people,

    I have a IRadvC5030 which refuses to boot, the display on the control panel will go to about 99 percent then just hang. I re-seated the DIMMS and replaced the HDD and put on the latest firmware, however, with the new HDD the control panel will now only go about half way then freezes, so ruling out the HDD, I am going back tomorrow with a set of DIMMs. If that fails, any other ideas?

    tks

    tip--make sure the cable from the reader controller is connected correctly. (not pitched or angled out)
    image below> shows the edge of the connector is parallel with the surface of the metal.



    are u able to get into service mode to check for any errors listed-

    & try in LEVEL1> COPIER> FUNCTION> SYSTEM> HD-CHECK>0, HD-CLEAR

    Leave a comment:


  • MunsterTech
    started a topic [Dead] IRadvc5030 - not booting

    IRadvc5030 - not booting

    hi people,

    I have a IRadvC5030 which refuses to boot, the display on the control panel will go to about 99 percent then just hang. I re-seated the DIMMS and replaced the HDD and put on the latest firmware, however, with the new HDD the control panel will now only go about half way then freezes, so ruling out the HDD, I am going back tomorrow with a set of DIMMs. If that fails, any other ideas?

    tks
Working...