ir 4570 error e100

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • ernesto
    Trusted Tech

    250+ Posts
    • Oct 2011
    • 430
    #1

    ir 4570 error e100

    Hi,

    I have an intermittent error 100,it has been changed laser unit, dce controller and removed laser shutter...
    Does anyone know what can be the problem.....?
    Tags: None
    • Helpdeskforum
      Technician
      • Jul 2016
      • 28
      #2
      Re: ir 4570 error e100

      replace dc controller did you do?
      very old machine ...
      maybe it's a bad contact from the metal registration roller to the little earth-spring at the side of this roller: clean the area there and some electro spray will take away this error

        Comment

        • blackcat4866
          Master Of The Obvious

          Site Contributor
          10,000+ Posts
          • Jul 2007
          • 22936
          #3
          Re: ir 4570 error e100

          I've always used conductive grease on that registration contact. or you'll get rust and screeching. I have not had any negative results from using the conductive grease. =^..^=
          If you'd like a serious answer to your request:
          1) demonstrate that you've read the manual
          2) demonstrate that you made some attempt to fix it.
          3) if you're going to ask about jams include the jam code.
          4) if you're going to ask about an error code include the error code.
          5) You are the person onsite. Only you can make observations.

          blackcat: Master Of The Obvious =^..^=

            Comment

            • ernesto
              Trusted Tech

              250+ Posts
              • Oct 2011
              • 430
              #4
              Re: ir 4570 error e100

              Originally posted by Helpdeskforum
              replace dc controller did you do?
              very old machine ...
              maybe it's a bad contact from the metal registration roller to the little earth-spring at the side of this roller: clean the area there and some electro spray will take away this error

              little earth spring.jpg

              does it mean that small metal ?

                Comment

                • Helpdeskforum
                  Technician
                  • Jul 2016
                  • 28
                  #5
                  Re: ir 4570 error e100

                  yep!

                    Comment

                    Previous template Next
                    Working...