while coping some times the print are not good please help regarding the problem weather it is scanar problem or mother board or any thing else in canon ir 3230
thanking you
thanking you
-
-
Re: please help regarding the error which is shown in pictures
Looks smeared. Fuser film? If not smeared then how about the drum -
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: please help regarding the error which is shown in pictures
Sir, try the test print in service mode if the output is same as your sample copy the drum and fuser is the problem.... If the test print is good the CIS or the flat cable would be the problem.Comment
-
Re: please help regarding the error which is shown in pictures
drum is changed yesterday and test print is good no any defect and also no any problem from p c print and no matter how much copy but in photocopy it occurs after 100 photocopy and no problem to 30 or 40 copy. no any fuser problem and no any problem in flat cable and not sure about cisComment
-
Re: please help regarding the error which is shown in pictures
If it smears go to am/copier/option/body/fix-temp and adjust up to see if that helps. What brand toner is in there?
Sent from my iPhone using TapatalkComment
-
Re: please help regarding the error which is shown in pictures
What media type? =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: please help regarding the error which is shown in pictures
Run a copy thru the bypass and set your paper setting to heavy bond paper, and run a regular 20lb sheet thru, if its good, then you know its fuser problem, like its being suggested, have seen this before, its more likely fuser.Comment
Comment