i have gp200 machine, past 10 days i have suffer from one problem at machine, there was f display on the screen at machine no other function not worked, what's the problem, what can i do, plz help me
-
-
Are you sure about that code?
There are no "F" codes, but a whole lot of "E" codes. If so, I'll need the whole code: E---, including the three numerical characters to be able to help you. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^= -
Sounds like the machine is cursing at you. Just kidding. Gonna need more than a "F" as a desription. Thanks.The glass maybe half full, but less is more...
Printer + Fax + Copier = Jack Of Many Trades,
but Master Of None
Color Copier = Not A Color Printer
InkJet MFP = Not A Fax Machine
B/W Copier = Not A Press
Finisher = Deal Closer (salesman, not accessory)
Copier Tech = Admin's Stress Ball (Scapegoat)Comment
-
F sign
Sorry,i have no idea.
My problem:When "F" sign appear,the LCD touch screen all hang and cannot touch the display and also sometime will cause machine off and on few time.I just disconnect the J526 and off and on back the machine."f " sign disappear and machine back to normal untill now.Comment
-
it is ip board problem. it shows the all capacitor in ip is lost its life. you replace all capacitor. the board will workComment
-
hey it is nothingya. the F came in the place of $ where leftside top corner. if small 'f' comes copier will work normally. and for service mode in activated condition. you no need to press star button.
if capital 'F' comes control panel will hang. machine stop workingComment
-
Yes sir, "F" display on the topleft corner, how can solve the control panel hang, and what can i do somebody told me remove the IP board and blow the hot air back side of board, but that is nonsense concept, but miracle machine came normal condition and work properly, but actual what problem and how can i solve it, sometime only it work proper and all the time not working, i need solution, plz help meComment
-
i already told you to replace the capacitor. due to moisture the capacitor lost its value. when you blow hot air the capacitor become dry and work again. so before you get the problem again you replace the capacitor. okComment
Comment