If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Ive had good luck with a drop of tri-flow on those oilite bushings and i normally try to take things apart if i can to clean the shaft and bushings ect. I will keep your info in mind. Drive units getting gummed up.
This is my thought, machine has done 1.7 million if a few drops of oil can get say 200k by then we'll put a new machine in this site.
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
Comment