Canon ImageRunner Advance C7570i III

[Eddie100]

I have a canon C7570i III with an error code E000029-1000. I did a hard reset on the unit and after the reboot that came up. Any advise would be greatly appreciated.

[copier tech]

Re: Canon ImageRunner Advance C7570i III

I have a canon C7570i III with an error code E000029-1000. I did a hard reset on the unit and after the reboot that came up. Any advise would be greatly appreciated.

Why did you perform a 'hard reset?' It sounds like the patch sensor is dirty, clean it.

• Code: E029-1000-05
• Description:Patch Sensor error
• Causes:The Patch Sensor detected correction error of the light intensity value determined at initialization.
• Remedy:[Related parts] R1.00 - Harness between the Multi Driver PCB (UN97/J1353) and the Patch Sensor (PS21/J7412) - Patch Sensor (PS21) - Multi Driver PCB (UN97) [Remedy] Perform the following in the order while checking whether the error is cleared. 1. If the sensor surface of the Patch Sensor is soiled, clean it with a cloth tightly wrung out of water. 2. Check/replace the related harness/cable, connector and parts. 3 Update system software

[dekoster]

Re: Canon ImageRunner Advance C7570i III


enter the standard values that are in the front door
in the service model
then switch the device off and on again
Don't forget to delete the error code

[Eddie100]

Re: Canon ImageRunner Advance C7570i III

enter the standard values that are in the front door
in the service model
then switch the device off and on again
Don't forget to delete the error code

[Phil B.]

Re: Canon ImageRunner Advance C7570i III

You need a manual.
Request one in 'Manual Request' forum.

Sent from my SM-G960U using Tapatalk

[Eddie100]

Re: Canon ImageRunner Advance C7570i III


You are a life saver. That was the issue. Thank you so much! God bless