iR400 head position short

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • nochick
    replied
    Thank you Brian8506

    Leave a comment:


  • Brian8506
    replied
    Could be registration clutch. Also there is a black pressure clip with a pressure spring on either side of the reg roller to apply pressure. These can break.

    Leave a comment:


  • nochick
    started a topic [CQ] iR400 head position short

    iR400 head position short

    there's 1 of my ir400 that head position short about 1.2 CM. from orginal and when i print meter out it's the same

    I try to adjust in service mode but it's not help much it , I reduce shorten to 0.7 Cm. but it's not enough

    please help

    Where should i look?

    paper try is normal

    Is it Regis position wrong?
Working...