If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
A brand new lbp674 not ejecting paper out of the fuser. Will run print job, then when you send 2nd job a jam is called because the last page from the 1st job is still under the fuser exit sensor. Any help is appreciated
A brand new lbp674 not ejecting paper out of the fuser. Will run print job, then when you send 2nd job a jam is called because the last page from the 1st job is still under the fuser exit sensor. Any help is appreciated
in the jams section, check if the flag sensor clips have come out of their seats
Comment