The ADF desappear of the panel....When I turn on the machine, the M4 of the ADF, works continuosly, and when I try to enter in the diagnostic mode, the feeder don't appear on the panel, just copier and finisher. I replaced the ADF controller PCB, and nothing...I cleaned every sensors, too, and checked the wires.
-
-
That certainly sounds like a pinched ground wire. It could be the motor itself. It doesn't sound like a problem the machine would cause, but if you have another 600 you might want to put the ADF on the other machine just to eliminate the host machine as the issue. Along with the wiring check that all pins are sitting properly in the sockets. Look for bent pins or ones that may have been pushed out.Is the glass half full or half empty? I say neither. The glass is obviously full, full of potential. The potential to hold more water or the potential to quench a thirst. Life is all about how you see it. -
Well, the Feeder appear on the panel, but the motor m4 continues workly continuoslyComment
-
I remember a case of replacing the copiers DC controller for these symptoms.
You might also recheck the condition of the pins in the pigtail connector. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
Comment