IR5000 F1 Finisher

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Dalamar
    Trusted Tech

    100+ Posts
    • Oct 2006
    • 117
    #1

    IR5000 F1 Finisher

    Finisher dog ears (bends the corner) on pages comign out of the finisher. Its been a few years since i've seen this and i can't remember the fix.

    too bad they don't have an unlit/broken light bulb for a post icon.
    Notatechie - "I am trying, but I don't know how to go into Service Mode. If I just go in and press *then 2, than 8, then * it does not do anything."
    SCREWTAPE - "Try harder.."


    Tags: arm, bad, bends, broken, corner, dog-ear, external, finisher, ir500, ir5000, light, occurring, pages, pass, upper
    • teckat
      Field Supervisor

      Site Contributor
      10,000+ Posts
      • Jan 2010
      • 16083
      #2
      Originally posted by Dalamar
      Finisher dog ears (bends the corner) on pages comign out of the finisher. Its been a few years since i've seen this and i can't remember the fix.

      too bad they don't have an unlit/broken light bulb for a post icon.
      First isolate where the dog-ear is occurring/ is it before entering Finisher ??
      move away/& run a copy
      if ok/check for any burrs on the buffer pass upper guide

      Upper Guide>FF6-0649-000.
      Last edited by teckat; 03-10-2010, 05:58 PM.
      **Knowledge is time consuming, exhausting and costly for a trained Tech.**

        Comment

        • kuby
          Senior Tech

          1,000+ Posts
          • Oct 2007
          • 1386
          #3
          Also need to check FB5-3394-000 ( ARM, FLAPPER) on the EXTERNAL DELIVERY UPPER ASSEMBLY
          and make sure it is not cracked.

            Comment

            Previous template Next
            Working...