47 results in 0.0232 seconds.
-
Toshiba MJ-1110 Finisher
I have a MJ-1110 Finisher when the pages come out of the middle exit tray the leading edge corner folds intermittently on the corner at the rear side... -
Bizhub C280 - Duplex pages folder in corner
Hi folks,
When copying to A4 duplex on my C280, the corner of some pages (~50%) come out with a small fold in the bottom left corner (image... -
df 3050 ARDF on a MPC3501 rear side corners folding
greetings
I looked at a mpc3501 that would fold every 3rd original very small lead edge corner on the NON OPERATIONAL side
of the machine.... -
C360 Document Feeder Folding Corner
The document feeder on my c360 folds the corner of the page only when running 2 sided copies. Has anybody seen this before, and what was your solution?... -
eStudio 233
Been working on an eStudio 233 that folds the leading edge of the page at the back corner. This happens only on Letter, not LetterR orientation. I have... -
Ir adv c55## adf scan copy skew
Hello gents. Maybe I am missing the proper keyword when searching.
I cant seem to find the why and how the image is skewing on 11x17 For... -
DF Skewing on MPC 3003
Hi all,
Having a problem where customer does a lot of design work, writes over the original then copies that sometimes up to 3 times. Each... -
X4220 printing 345X
Hi Everyone
I got a machine X4220 that is printing randomly in between jobs 345X on the top left corner.
I have done HHD recovery... -
IRA-8095 FM30 location
Copier has an E820-0000 code for the developer lower cooling fan FM30. I ordered the fan, went to install it and can't locate it's placement. The service... -
Mpc4500 corner fold in fuser letter only
Letter R goes through fine but standard letter Folds corner through fuser.
fuser is good looking and shows no wear -
MP4054 with bad skewing
I've got a 4054 that is about 1.5yrs old with just under 180,000 copies on it that is skewing test patterns badly. Even with the paper buckle set to -4... -
Corner of paper folded over Canon c7055
When printing long edge first the leading edge top corner is occasionally folded over. This doesn't happen every page and is printed over so I am assuming... -
Bent corners on Bizhub 20 solution
Bent corners, happened between drum and fuser. I knew this because the whole image was present on the paper, even under the bent corner.
Turned... -
552ci touch panel
Hi
Got a 552ci touch panel, not responding properly in one corner, have cleaned round the edges, and calibrated U201. It worked for a while... -
Staple in stack sorted
Hi
Does anyone know how to put a corner staple in a stack-sorted print-copy on Ricoh machines (all new models, mpcxxxx etc.)?
...
