ir 4570 copycards

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • johnner66
    Trusted Tech
    • Mar 2009
    • 265
    #1

    ir 4570 copycards

    after taking out the copycards system how can i disable it thanks
    Tags: 130, 4570, card reader, connector, control, copier, disable, good, harness, ir500, ir5000, lef, left, mileage, nec, plug, service, shorting, sys, system, systems, vary, wire
    • SCREWTAPE
      East Coast Imaging

      Site Contributor
      2,500+ Posts
      • Jan 2009
      • 3396
      #2
      Originally posted by johnner66
      after taking out the copycards system how can i disable it thanks
      Can you expain, what are copycards?

        Comment

        • mrfixit51
          Lead Service Technician

          1,000+ Posts
          • Oct 2008
          • 1975
          #3
          Originally posted by johnner66
          after taking out the copycards system how can i disable it thanks
          Most copycard systems hookup to the copier wire harness thru a plug. The connector has a jumper plug on it that is normally left in place near this connector. When the system is disconnected, the jumper plug is reattached to the harness, and the copier is normally good to go again. At least that is how it was done in the olden golden days of yore,,, your mileage may vary of course...

          That is why it is important to leave the installation instructions for that device with the copier...
          "Once a King, always a King, but once a Knight is enough!"

            Comment

            • costd
              Technician

              250+ Posts
              • Jan 2008
              • 409
              #4
              Another possibility - if you used a control card just turn it off (service mode level 2, Copier>option>acc>cc-spsw). I remember using the shorting plug for the card reader on the iR5000 and NP6050, but (myself) have not used it on a 4570.

                Comment

                • SCREWTAPE
                  East Coast Imaging

                  Site Contributor
                  2,500+ Posts
                  • Jan 2009
                  • 3396
                  #5
                  Ahh, Card reader. That's the term I'm familiar with.

                    Comment

                    • teckat
                      Field Supervisor

                      Site Contributor
                      10,000+ Posts
                      • Jan 2010
                      • 16083
                      #6
                      Originally posted by johnner66
                      after taking out the copycards system how can i disable it thanks

                      go into service mode Level 2 COPIER > OPTION > ACC and set CC-SPSW to "0".
                      **Knowledge is time consuming, exhausting and costly for a trained Tech.**

                        Comment

                        Previous template Next
                        Working...