ir600 Jams going into Saddle Finisher

[mrfuser]

Okay, copier works great without finisher. We have 2 of these doing the same exact thing. Paper just does not seem to be pushed enough to get it into the saddle finisher even when connected properly. It works once in a while, but most of the time the paper just falls down between finisher and copier.

Any ideas?

Kelly

[charm5496]

sounds like you are missing the exit gate that goes on the exit of the copier
FB4-8724-000

[teckat]

D2.JPG
Saddle Finisher D2-GUIDE LOCATION/ posted by charm5496

ALSO CHECK YOUR D2-HEIGHT ADJUSTMENT TO IR600

[mrfuser]

I have the gate installed on both. I will check height adjustment.

Kelly

[mrfixit51]

sounds like you are missing the exit gate that goes on the exit of the copier FB4-8724-000

Ah yes,,, the infamous Chicken Lips!