IR5570 noise

[bartman]

As the fuser periodically rotates during standby it makes a noticable (not loud) rattling noise. Is there a known part or parts that need to be replaced or is this just normal for the IR5570? Thx

[android790]

I have had the lower fuser bearings make noise. Or the shaft they ride on gets worn

[ReproKev]

I only have a couple of them in the field, but it could be the shutter inside the upper fuser roller. I know it moves depending on what size paper is being run but not sure about during standby.

[CanonSco]

I also have had a couple of shutter issues giving noise with these.

Most recently I had the shutter HP sensor come off it holder ( PS53 ) causing the shutter to chatter constantly. This machine also had , I think , E840's in the history.
Also on that one I remember the noise continued even after the front door was opened , only stopping when unit 1 was pulled out.

As said , the LFR bearings can also make noise.

[Herrmann]

check the lower fuser roller, after some time, it gets dents, causing the rattling noise

[SCREWTAPE]

Replace the lower roller.

Part# FM2-4683-000 (Newer Type) Comes with the bearings.

[bartman]

Thank you for the helpful responses. I did replace LFR and bearings. This did not fix the noise. It appears the noise is in the upper fuser assembly or the feeder assembly (transport). I did not have time to track it down and will have to tackle it later. Thx again.

[SCREWTAPE]

Check the gears in the upper fixing assy.

Could also be the shutter inside the fixing roller.

But there usually an error code associated when the shutter go haywire.

["Harvey Dent"]

Check for error codes, E840, E14.

[Canuck]

UFR gears on both ends crack all the time....machine will click or knock. The front gear turns the UFR, the rear gear drives the transport gear for the belts. Usually see a slight smear on long paper(jerks paper during transfer)

[teckat]

As the fuser periodically rotates during standby it makes a noticable (not loud) rattling noise. Is there a known part or parts that need to be replaced or is this just normal for the IR5570? Thx

what does it sound like/
post a sound link

rattling noise

http://alwayshd.com/ViewClip.php?Clip_Name=911710539&Tape_Name=9117105

[jsw2k]

Ditto the LFR bearings...also, check the bushings on the upper part? I seem to recall having trouble with them too.

[SCREWTAPE]

I believe he said he replaced the Lower pressure roller and bearings. He should check the shutter.

When the shutter tries to find home position, it rotates back and forth until it finds it.
This is within 1 to 2 seconds when the machine is powered on. If the it does not find it, it will rotate back and forth making a rattling sound. There's sometimes a E840.

[teckat]

I believe he said he replaced the Lower pressure roller and bearings. He should check the shutter.

When the shutter tries to find home position, it rotates back and forth until it finds it.
This is within 1 to 2 seconds when the machine is powered on. If the it does not find it, it will rotate back and forth making a rattling sound. There's sometimes a E840.

Rattling Noise Audio
HD Video Clip

[Canuck]

The upper fuser roll gears crack all the time on these machines...front and rear. I've replaced at least 10 sets for cracks between the gear teeth. If you keep running it the gear will split in half...been there!!! I'll bet a cold beer, that you got a cracked gear...