when running duplex letter the backside image is shifting towards the rear. sometimes it stays right on. I have another 7095 right next to it doing about the samething. the shifting varies up to an 1/8 of an inch. thanks....
-
-
Does it have a sensor in the duplex path to measure the shifting of the paper? -
no just a sensor in the middle of the path (duplex)Comment
-
<Duplexing Transport Unit>
Make following adjustments under,
COPIER > ADJUST > FEED-ADJ > ADJ-REFEUse this to adjust the horizontal registration for re-pickup (2nd side of 2-sided print).
Increase the value if the image is displaced to the front. Range: -100 to 100_
(unit: 01 mm)
margin by 1 mm).
1) Make the following selections in service mode:
COPIER > ADJUST > FEED-ADJ > ADJ-REFE
so that the image margin on the 2nd
side will be as indicated.
- If the margin is too large, decrease the setting
of ADJ-REFE (a change of 10 will decrease
the margin by 1 mm).
- If the margin is too small, increase the setting
of ADJ-REFE (a change of 10 will increase theComment
Comment