On C3220, doc feeder jams on multiple copies, 1 copy passes through feeder fine but if you have 2 originals in feeder, the 1st copy jams at exit. Also won't reverse process for duplexing, jams when trying to take back in to turn over. I have 2 with this exact problem so must be something fairly common that we are just missing.
-
-
DADF CONTROLLER
DCC.JPG
inspect & clean all rollers
Replace Separation pad
remove cover below to get to pad
DADF.JPG
U need to use dip switches on DADF CONTROLLER to release pressure of roller to pad unit-for easy removal to replace pad- DO NOT FORCE OUT UNIT, IF U DON'T KNOW HOW TO USE DIP SWITCHES
BITS.JPG
DADF2.JPG
CLEAN ROLLER BELOW
D10.JPG
there is a procedure to replace roller unit/ it is a little complicated to explain here if u never attempted it before /
best advise get a DADF B1-K1 Service manual**Knowledge is time consuming, exhausting and costly for a trained Tech.**
-
hi,your problem could be in fact a small spring has come off a deflector and it not moving properly,if you open up the right hand cover and look inside you should see the metal plate that the spring goes on and the small hole in deflector for the other end of spring.Comment
-
TWO-SIDED ISSUE DADF
imageRUNNER C2620 / 3200 /3220
DADF K1 Two Sided Jams in the Feeder
2 to 2 sided copies, paper stops in the reverse delivery area.
Open the Reverse Delivery Cover and make sure the mylar on the cover is not missing or damaged. If necessary, replace the mylar.
The Part Number for the Mylar is FB5-2207-010.
A picture of the Mylar is below.
IMG_6951[1].jpgLast edited by teckat; 11-04-2010, 05:29 AM.**Knowledge is time consuming, exhausting and costly for a trained Tech.**Comment
-
-
Thanks guys, there was a break in the flag arm that the tech didn't notice at first glance.Comment
-
**Knowledge is time consuming, exhausting and costly for a trained Tech.**Comment
Comment