IR5000 : How to force to copy/print ONLY face up

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • mrfixit51
    Lead Service Technician

    1,000+ Posts
    • Oct 2008
    • 1975
    #16
    Originally posted by andalasgt
    Thank you, I will learn it. ...
    These parts are needed to rebuild the fuser exit/inversion area to get rid of ripped legal length copies from slowing up in the inversion process.

    FB6-5892-000 Roller

    FB6-5895-000 Roller

    FB6-5896-000 Roller

    FS7-0660-020 1-way Gear

    FS7-0664-020 1-way Gear
    "Once a King, always a King, but once a Knight is enough!"

      Comment

      • teckat
        Field Supervisor

        Site Contributor
        10,000+ Posts
        • Jan 2010
        • 16083
        #17
        here are other locations of parts mrfixit51 mentions in his reply
        SHAFT.JPG
        #97=FB6-5896-000 /Shaft, Roller
        #114=FS7-0660-020 /1-way Gear
        #100=FS7-0664-020 /1-way Gear
        #300=FB6-5892-000 /Roller
        FB6-5895-000 Roller,is shown on other pic above
        **Knowledge is time consuming, exhausting and costly for a trained Tech.**

          Comment

          • andalasgt
            Technician
            • Oct 2010
            • 49
            #18
            It seems quite difficult to disassembly it, but i will try to do it this weekend.
            Thank you for your description.

              Comment

              • mrfixit51
                Lead Service Technician

                1,000+ Posts
                • Oct 2008
                • 1975
                #19
                Originally posted by andalasgt
                It seems quite difficult to disassembly it, but i will try to do it this weekend.
                Thank you for your description.
                It is not really that difficult, just remove the fan assembly in the front, the drive motor on the rear of the assembly, and shields as necessary...
                Last edited by mrfixit51; 06-02-2011, 04:15 PM.
                "Once a King, always a King, but once a Knight is enough!"

                  Comment

                  Previous 1 2 template Next
                  Working...