Canon IRC3200 not printing after removing ImagePass

[ZeitaIT]

to clarify, I can P-Print from the copier itself while in service mode..

[KenB]

to clarify, I can P-Print from the copier itself while in service mode..

Being able to "print" from P-Print means nothing (at least for printing, anyway).

It's only an internal report which has nothing to do with the printing option.

[teckat]

I didn't notice your reply up there. So I hooked the imagepass back but the copier can't see it. Still can see "send" for scan to email which is good and I can scan to email. But I can't get the imagepass back online?? what are we missing...

Note: When the IMG-CONT value is set to any number other then a 0;
the network settings must be configured on Fiery device setup.

In service mode select Function level one, Clear MMI. Next turn off the machine. This process will clear backup data for the copy operation panel.

Note: It will be necessary to re-select the printer option and set it to "3" after this procedure.


did u put back the I/F PCB for the C1 ????

see pdf>>>>>>>>>>>>>imagePass C1 v2 Install.pdf

[KL568]

Note: When the IMG-CONT value is set to any number other then a 0;
the network settings must be configured on Fiery device setup.

In service mode select Function level one, Clear MMI. Next turn off the machine. This process will clear backup data for the copy operation panel.

Note: It will be necessary to re-select the printer option and set it to "3" after this procedure.


did u put back the I/F PCB for the C1 ????

see pdf>>>>>>>>>>>>>[ATTACH]10493[/ATTACH]

Thanks, Teckat for supplying the PDF file. It will make explanation much easier.

ZeitaIT

On Sub-heading 2.3 of Page 6 is the LCD screen that allows you to configure settings / make configuration printouts / etc...

[adween]

have you try UFR driver? i have i unit machine cant use pcl and ps. but when i use UFR can works.

[ZeitaIT]

IT WORKS NOW.

Ok after shutting down the machine and the server. Reseated all cards (mem. pci just to make sure) both on the printer and the c1. Turned on both machines and reset imgcnt to 0 then back to 3. Reboot again and now it wokrs (it took a good 5 minutes to come on). But it is on now and with ImagePass printing works for all including Mac. So Thanks all for the help and great suggestions!

[teckat]

the imagePass C1 older ver.is a pain in the but- if it is not shut down properly

[KenB]

the imagePass C1 older ver.is a pain in the but- if it is not shut down properly

And THAT's giving it more than it deserves!