[CQ] Imagerunner 9060pro

[jorm]

Dear sirs

Would like to know your opinion on this auto gradation test if it is normal.

1 should the lowest 5 rows be totally white
2 the grey center is veru moisy is that normal

This is done on Canon 105gr High grade paper.

Best regards
jorm

[teckat]

Re: Imagerunner 9060pro

Test Print
For automatic gradation correction, test print is performed to 4 sheets. Dmax-Pascal control
is performed, using 1 out of these 4 sheets.

auto.JPG

what does your MCYBk Horizontal Line (TYPE=10)
print look like ??????
NORMAL=
pg10.JPG
PG12-14 ???? check them-
PG12-14.JPG

[jorm]

Re: Imagerunner 9060pro

Picture you have attached is something im looking for in my machine, what could be wrong in my machine?

Why is my tests so bad?

I have done test with all four sheets but all the same.

jorm

Test Print
For automatic gradation correction, test print is performed to 4 sheets. Dmax-Pascal control
is performed, using 1 out of these 4 sheets.

[ATTACH=CONFIG]12655[/ATTACH]

[teckat]

Re: Imagerunner 9060pro

Picture you have attached is something im looking for in my machine, what could be wrong in my machine?

Why is my tests so bad?

I have done test with all four sheets but all the same.

jorm

your Gray Scale is off

did u run those test prints I posted ???

PG10-PG12-PG14 ????? to inspect

[jorm]

Re: Imagerunner 9060pro

Sorry for my knowledge in this, but how are these tests done'

Jorm

your Gray Scale is off

did u run those test prints I posted ???

PG10-PG12-PG14 ????? to inspect

[charm5496]

Re: Imagerunner 9060pro

service mode>copier>test>PG input your test page number in PG-TYPE and choose OK. Go to page 2 and choose your drawer selection and quantity hit ok for both and then hit your start button.

I would highly recommend getting a manual for this machine. Also when in service mode there is a green button at the bottom of the screen which gives you a description of the test mode menu.

[jorm]

Re: Imagerunner 9060pro

Found out how this is done, here are the tests

[charm5496]

Re: Imagerunner 9060pro

so do you still have concerns with the quality of this machine? Did the colors and grey output improve after running the auto gradation?
Is your paper type set correctly? Are the drums, developer and ITB in good condition?

The first auto gradation page you ran looks normal with the white space.

[jorm]

Re: Imagerunner 9060pro

When you say paper type set correctly? can you give me a little more description, ( i just choose plain 2 because i have 100gr paper)

jorm

so do you still have concerns with the quality of this machine? Did the colors and grey output improve after running the auto gradation?
Is your paper type set correctly? Are the drums, developer and ITB in good condition?

The first auto gradation page you ran looks normal with the white space.

[charm5496]

Re: Imagerunner 9060pro

that is correct.
Also has the ITB upgrade kit been installed along with the latest firmware release?

[teckat]

Re: Imagerunner 9060pro

Sorry for my knowledge in this, but how are these tests done'

Jorm

Calibration iRADVANCE C SERIES PDF's/ LINK BACK___below

http://www.copytechnet.com/forums/ca...t-revised.html