[CQ] IR8500 Output smudge/white line

[mezerwi]

Hi,

It happen when the machine being shut down for 2-3 days.

IMAG0734 (Large).jpg

Image above is generate using PG 1 test print.

Does it relate with the laser?

Mezerwi

[kingpd@businessprints.net]

Re: IR8500 Output smudge/white line

Is it consistent every time at the same spots or random? Does it do it when printing and copying from different sources?

[mezerwi]

Re: IR8500 Output smudge/white line

Is it consistent every time at the same spots or random?
Almost consistent

Does it do it when printing and copying from different sources?
Yeah

[kingpd@businessprints.net]

Re: IR8500 Output smudge/white line

Have seen similar things in that family but not exactly the same as yours.

Recommended things to check, start with the easiest:

1. is it on a carpet
2. is the electrical sufficient and properly grounded
3. have you cleaned or replaced the coronas
4. how old is the developing unit/when was it last changed
5. when was the last time the drum blade was replaced (i think they're good for like half a million then you flip them)
6. other thoughts, power board bad laser near death

Seen these issues before in same family but I never got to the bottom of it before replacing since newer machines were cheaper than parts but I'd bet the problem lies in the above.

It's a lot of potential areas to check and I wouldn't just go buy new parts, you want to try and hone in on the problem, although it can be a b*tch at times.

teckat, blackcat, or charm do canons more i think so maybe they can offer better advice.

Good luck and let us know of further developments.

[vigour]

Re: IR8500 Output smudge/white line

HOW MANY COPIES ON M/C?
is it on letter paper too?
looks like a flat spot on some roller, or a gear issue, some hesitation along the path.
stop m/c see if it shows up before the fuser
lower fuser roller, reg roller maybe

[mramlawi]

Re: IR8500 Output smudge/white line

change the corona's and check the develpoment unit check the bering inside ,check the drum if there's something jamed and u couldnt see it till u disassemble .
reply to us

[gensys]

Re: IR8500 Output smudge/white line

Hi,

It happen when the machine being shut down for 2-3 days.

[ATTACH=CONFIG]13155[/ATTACH]

Image above is generate using PG 1 test print.

Does it relate with the laser?

Mezerwi

Change the corona's & Drum