Internal Finisher-S1 on iR-3570

[blackcat4866]

Re: Internal Finisher-S1 on iR-3570

Also to add after replacing items 14 remove the small pads item 33 they get sticky & cause all kinds of problems.

I'll watch for it, thanks.

The problem I'm having is very intermittent, as in approximately once a year. When the finisher jams are removed a certain way the front gripper hooks onto a feature on the base plate, and cannot return to home position. It gives a E000575-8001 error. It's a 5 minute recovery: pick up on the gripper so it releases, reset Limited Function mode, flip power Off/On. But the enduser is getting agitated. Each of these parts is showing significant wear from the constant back/forth scraping. I've been in there once before so I know what it looks like: lots of mechanical gears and cams. Fun like the iR330 paper feed units ***sarcasm***.

=^..^=

[Canon.Tech]

Re: Internal Finisher-S1 on iR-3570

Also to add after replacing items 14 remove the small pads item 33 they get sticky & cause all kinds of problems.

[blackcat4866]

Re: Internal Finisher-S1 on iR-3570

Not quite, but thanks anyhow. I found a manual. =^..^=

[zoraldinho]

Re: Internal Finisher-S1 on iR-3570

Check this

Binder1.pdf

[blackcat4866]

Re: Internal Finisher-S1 on iR-3570

If you're looking for the base that the upper assembly sits on it's 4A3-1047-000 called lower guide

Just to confirm, Brian, it's the same slotted guide that the grippers ride on? It's gouged up pretty badly by the action of the grippers.

... and the grippers?
=^..^=

[Brian8506]

Re: Internal Finisher-S1 on iR-3570

If you're looking for the base that the upper assembly sits on it's 4A3-1047-000 called lower guide

[blackcat4866]

Re: Internal Finisher-S1 on iR-3570

Thanks zoraldinho. The rollers are (2) 4A3-1121-000

... and the grippers, and base plate? =^..^=

[zoraldinho]

Re: Internal Finisher-S1 on iR-3570

Binder1.pdf

[blackcat4866]

I'm looking for part numbers for the gripper assembly, the base that the gripper travels over, and the two large eject rollers.

Or use of a parts manual would due just fine. Our local manuals guy was unable to find that particular one.
Can anybody help?
=^..^=