Canon IR 2620 - Feeder problems

[Guest]

Hi everybody

Just brought one of these, the copier works fine and I was shown the feeder working. However when I got it setup the feeder worked the first day and never again. I've checked the cables and don't see any problems. Is there any other way to check what's happened. I get no green light from the feeder but if I unclip the cable the printer does recognise the feeders been disconnected. Any help would be appreciated.

[Luther]

Re: Canon IR 2620 - Feeder problems

you shouldnt get a green light until paper is present in the feeder, i would open the cover and check to see if the sensor arm is off or stuck.if the feeder doesnt detect paper it wont feed

[aumir1]

Re: Canon IR 2620 - Feeder problems

Thanks, I'm pretty new to this photocopier, is there a picture or diagram somewhere that shows what the correct position for the arm should be or where exactly its located?

[teckat]

Re: Canon IR 2620 - Feeder problems

Hi everybody

Just brought one of these, the copier works fine and I was shown the feeder working. However when I got it setup the feeder worked the first day and never again. I've checked the cables and don't see any problems. Is there any other way to check what's happened. I get no green light from the feeder but if I unclip the cable the printer does recognise the feeders been disconnected. Any help would be appreciated.

see this link below

http://www.copytechnet.com/forums/ca...-k1-issue.html

[aumir1]

Re: Canon IR 2620 - Feeder problems

see this link below

http://www.copytechnet.com/forums/ca...-k1-issue.html

Thanks for your help problem solved. It turned out to be the sensor on the feeder not berring pressed all the way down when the feeder was closed.

[teckat]

Re: Canon IR 2620 - Feeder problems

Thanks for your help problem solved. It turned out to be the sensor on the feeder not berring pressed all the way down when the feeder was closed.

Thumbs up.jpg