[Jamming] Canon IR3570

[sniper2g8]

Initially the machine was jamming and showing error code E00007-000 and I changed the fuser sleeve and the lower roller. the code has been cleared but A4 and A3 sheet always keep jamming only A4R print fine.
please help.......

[Blizzoo]

Re: Canon IR3570

I belive that the film sleeve doesn't turn in right speed,maybe grease problem.Are the pressure bushings worn/"dusting"?

[sniper2g8]

Re: Canon IR3570

I belive that the film sleeve doesn't turn in right speed,maybe grease problem.Are the pressure bushings worn/"dusting"?

Please can I have a look of the pressure bushing

[sniper2g8]

Re: Canon IR3570

The jamming code 0108

[Brian8506]

Re: Canon IR3570

Did you clean the old grease off and put new "good" grease on the heater element? Are the copies blurry? If so, that could be a sign of bad or no grease. Also paper moisture this time of year causes lots of problems. Paper runs better in the R direction when humidity is high

[teckat]

Re: Canon IR3570

The jamming code 0108

-----------/
0108 code is a delay jam to the No.1 delivery sensor, PS14.

Check the operation of the Fixing delivery reverse flapper

checked delivery shaft ?
coping or printing or both ?
is this from any paper source?

[sniper2g8]

Re: Canon IR3570

Did you clean the old grease off and put new "good" grease on the heater element? Are the copies blurry? If so, that could be a sign of bad or no grease. Also paper moisture this time of year causes lots of problems. Paper runs better in the R direction when humidity is high

I cleaned the old grease out and put new good grease
the R direction only jam for the first two copies when the printer is turned on but the A3 always keep jamming

[Brian8506]

Re: Canon IR3570

Black damper pads for delivery flapper probably worn and sticky. Those will cause 0108 jam

[teckat]

Re: Canon IR3570

as noted by Brian8506

DAMPER PAD LOCATIONS