Copyboard fell off

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • evest
    Technician
    • Aug 2008
    • 58
    #1

    [Misc] Copyboard fell off

    Fixing on an imagerunner 2200 and the copy board fell off. I see alot of foam pads with bad adhesive that most like held it on. Do some of you know a way around ordering the pads. machine not worth the cost of the pads most likely.
    Thanks.
    Tags: None
    • teckat
      Field Supervisor

      Site Contributor
      10,000+ Posts
      • Jan 2010
      • 16092
      #2
      Re: Copyboard fell off

      Originally posted by evest
      Fixing on an imagerunner 2200 and the copy board fell off. I see alot of foam pads with bad adhesive that most like held it on. Do some of you know a way around ordering the pads. machine not worth the cost of the pads most likely.
      Thanks.


      Velcro / or
      Double Sided Foam Adhesive Tape

      **Knowledge is time consuming, exhausting and costly for a trained Tech.**

        Comment

        • blackcat4866
          Master Of The Obvious

          Site Contributor
          10,000+ Posts
          • Jul 2007
          • 22693
          #3
          Re: Copyboard fell off

          Me too. I prefer the sticky Velcro. It's easier to position or re-position the matt. 1" square pads or 1" roll cut into 1" lengths works quite nicely. Take the time to remove the old adhesive or it won't adhere very well. =^..^=
          If you'd like a serious answer to your request:
          1) demonstrate that you've read the manual
          2) demonstrate that you made some attempt to fix it.
          3) if you're going to ask about jams include the jam code.
          4) if you're going to ask about an error code include the error code.
          5) You are the person onsite. Only you can make observations.

          blackcat: Master Of The Obvious =^..^=

            Comment

            • Canuck
              Tech Specialist

              1,000+ Posts
              • Nov 2007
              • 1713
              #4
              Re: Copyboard fell off

              Weatherstripping....use it all the time. Clean the old glue from the old copyboard. I use 3/4 inch wide about 3/16 thick(get it from Home Depot). Cut into squares, then heat a glue stick with a lighter,dab some glue on copyboard, then place foam square FOAM SIDE down onto glue. Peel off white paper on each, line up the copyboard, and install into place. Works like a charm

                Comment

                • teckat
                  Field Supervisor

                  Site Contributor
                  10,000+ Posts
                  • Jan 2010
                  • 16092
                  #5
                  Re: Copyboard fell off

                  Originally posted by Canuck
                  Weatherstripping....use it all the time. Clean the old glue from the old copyboard. I use 3/4 inch wide about 3/16 thick(get it from Home Depot). Cut into squares, then heat a glue stick with a lighter,dab some glue on copyboard, then place foam square FOAM SIDE down onto glue. Peel off white paper on each, line up the copyboard, and install into place. Works like a charm


                  good point/ suggestion

                  always ask if can use a open flame in customers office


                  **Knowledge is time consuming, exhausting and costly for a trained Tech.**

                    Comment

                    Previous template Next
                    Working...