C451 Transfer Belt Drive Problem

[mrfuser]

Re: C451 Transfer Belt Drive Problem

Anyone have any other thoughts? I went back and replaced the gear assembly again with updated gears for transfer drive. It works perfect, but right away I could see it shred a little bit of the gear as flakes of white plastic flew down. I don't see anything binding to cause this and even put another belt assembly in. Any thoughts?

Does anyone one have a pic of this installed to make sure I am not doing something wrong here?

[copier tech]

Re: C451 Transfer Belt Drive Problem

What sort of count is this old dog on?

[mrfuser]

Re: C451 Transfer Belt Drive Problem

Total about 500k

[srvctec]

Re: C451 Transfer Belt Drive Problem

Sounds like a worn bushing somewhere or something similar that is keeping the gears from meshing properly.





"It's time to be CORRECT, NOT politically correct!!!"

-The Truth

[habik]

Re: C451 Transfer Belt Drive Problem

Try different Waste box and have a look at the waste box gear drive if it ain't stiff

[tehrancopy.com]

Re: C451 Transfer Belt Drive Problem

Change the Transfer Cleaning Motor . The motor shaft sometimes get worn out and it will cause damage to the gears .

https://WWW.tehrancopy.com

[matsan_offset@yahoo.com]

Re: C451 Transfer Belt Drive Problem

Client complained of clicking/grinding sound and found that the Transfer Belt drive gear cluster was not staying engaged on exit side of belt area. We replaced that gear cluster and complete belt assembly and now it has come back again.

Any ideas why?

Thanks all!

Hello, has your problem been solved? I have the same problem as yours.

[Phil B.]

Re: C451 Transfer Belt Drive Problem

Hello, has your problem been solved? I have the same problem as yours.

did you read any posts past Mr Fuser's original post?