Bizhub C220 has grinding noise during warm-up and while making copies

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • titanscout
    Technician
    • Oct 2013
    • 24
    #1

    [Misc] Bizhub C220 has grinding noise during warm-up and while making copies

    I checked out the fuser and it looks fine, and the noise doesn't seem to be coming from this area. Also pulled the toners and the waste-tank out, blocked the sensors so it would run, and it still made the same noise while running copies. What do you think? Thanks
    Tags: None
    • Woxner
      Senior Tech

      500+ Posts
      • Jul 2011
      • 838
      #2
      Re: Bizhub C220 has grinding noise during warm-up and while making copies

      most of the time it a blocked up auger either transfer cl unit or collection auger

        Comment

        • copyman
          Owner / Technician

          Site Contributor
          2,500+ Posts
          • Sep 2005
          • 4618
          #3
          Re: Bizhub C220 has grinding noise during warm-up and while making copies

          Wox is spot on. There is a bulletin about this. The chute for waste box gets packed with toner. Remove the waste box, then remove the chute (1 screw), vacuum out the packed toner and trim mylars in chute, reassemble and you will be good to go.
          Last edited by copyman; 08-22-2016, 05:34 AM.

            Comment

            • Hansoon
              Field Supervisor

              Site Contributor
              2,500+ Posts
              • Sep 2007
              • 3374
              #4
              Re: Bizhub C220 has grinding noise during warm-up and while making copies

              Yep, just had it last Friday with a BH-C-280. Toner was blocking the waste toner chute just above the waste toner tank.

              Hans
              “Sent from my Intel 80286 using MS-DOS 2.0”

                Comment

                Previous template Next
                Working...