Bizhub 454e

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • blackcat4866
    Master Of The Obvious

    Site Contributor
    10,000+ Posts
    • Jul 2007
    • 22997
    #16
    Re: Bizhub 454e

    I just heard the solution to this one:

    It turned out to be drive resistance in the fuser drive. If set to Thick media type, the engine slows down enough to pass several hundred pages without a hitch. Our tech cleaned and lubricated the fuser drive pack.

    Maybe this will help someone. =^..^=
    If you'd like a serious answer to your request:
    1) demonstrate that you've read the manual
    2) demonstrate that you made some attempt to fix it.
    3) if you're going to ask about jams include the jam code.
    4) if you're going to ask about an error code include the error code.
    5) You are the person onsite. Only you can make observations.

    blackcat: Master Of The Obvious =^..^=

      Comment

      • onlynamenotused
        Junior Member
        • Jul 2017
        • 3
        #17
        Re: Bizhub 454e

        Possibly another occurrence of this issue. We swapped a FS533 from a 454e to a c284. Since the finisher swap the C284 with a FS533 fitted will jam every page in the finisher when printing long edge first, short edge first doesn't jam.

        Removed the finisher and tested in the workshop on another C284, no problem. Both short/long edge print fine.

        Reinstall the FS-533 at customer site and it jams every page still.

          Comment

          • kingarthur
            Service Manager

            1,000+ Posts
            • Feb 2008
            • 1325
            #18
            Re: Bizhub 454e

            Originally posted by onlynamenotused
            Possibly another occurrence of this issue. We swapped a FS533 from a 454e to a c284. Since the finisher swap the C284 with a FS533 fitted will jam every page in the finisher when printing long edge first, short edge first doesn't jam.

            Removed the finisher and tested in the workshop on another C284, no problem. Both short/long edge print fine.

            Reinstall the FS-533 at customer site and it jams every page still.
            Read my earlier post.......It's the machine exit that's the problem, nothing to do with the FNS , there's a tech bulletin TAGB1600344EN, that tells you what to do, i tried a couple of times to strip/lube it, it only worked when I used drysurf
            Tip for the day; Treat every problem as your dog would.....If you cant eat it or f*ck it....then p*ss on it & walk away...

              Comment

              Previous 1 2 template Next
              Working...