Black line C258

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • darry1322
    Senior Tech

    Site Contributor
    500+ Posts
    • Oct 2010
    • 817
    #16
    Re: Black line C258

    Originally posted by allan
    Mag roller?

    Mag roller on mine was great.
    At first I checked the fuser. All good there.
    Then I checked the drum. Looks good.
    Finally pulled the dev unit. Perfect.
    Since it looked like a drum issue I just replaced the drum and went back to great copies.

    Bix may have a different issue. I'm simply saying that a drum or charge roller may look great but still be bad.

      Comment

      • blackcat4866
        Master Of The Obvious

        Site Contributor
        10,000+ Posts
        • Jul 2007
        • 22989
        #17
        Re: Black line C258

        Originally posted by allan
        Something on the charge roller?

        If that is the case i will have a wack at cleaning it.
        Did you see the repetitive defect at ~24mm? Jip, primary charge. But don't try to clean it. It will get a lot worse. =^..^=
        If you'd like a serious answer to your request:
        1) demonstrate that you've read the manual
        2) demonstrate that you made some attempt to fix it.
        3) if you're going to ask about jams include the jam code.
        4) if you're going to ask about an error code include the error code.
        5) You are the person onsite. Only you can make observations.

        blackcat: Master Of The Obvious =^..^=

          Comment

          • Bix
            Service Manager

            1,000+ Posts
            • Apr 2018
            • 1421
            #18
            Re: Black line C258

            Hi, here's an update.


            Today I replaced it with a black drum.


            Unfortunately it didn't solve the problem. I did the patterns printing and the line appears in all colors.


            I pulled the strap out, it looks good but manually turning I noticed that it leaves a slight strip. In fact, after making it turn manually, I made 5-10 prints and the line did not appear, only to appear again.


            Maybe there's something inside the belt cleaning blade. I will try to replace it. What do you think?as1.jpgas2.jpg

              Comment

              • Bix
                Service Manager

                1,000+ Posts
                • Apr 2018
                • 1421
                #19
                Re: Black line C258

                Solved

                Cleaning blade did not clean at one point. There was a small groove in the transfer belt. replaced

                  Comment

                  Previous 1 2 template Next
                  Working...