Bizhub C253 Magenta/Black Stripes across the page

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • blackcat4866
    Master Of The Obvious

    Site Contributor
    10,000+ Posts
    • Jul 2007
    • 23008
    #16
    Re: Bizhub C253 Magenta/Black Stripes across the page

    Originally posted by Fretek
    So I guess all I can do now is to order a new transfer belt unit with the Nr A02ER73022, is this correct?
    Correct. You'll need to do a color calibration after it's installed. =^..^=
    If you'd like a serious answer to your request:
    1) demonstrate that you've read the manual
    2) demonstrate that you made some attempt to fix it.
    3) if you're going to ask about jams include the jam code.
    4) if you're going to ask about an error code include the error code.
    5) You are the person onsite. Only you can make observations.

    blackcat: Master Of The Obvious =^..^=

      Comment

      • Fretek
        Junior Member
        • Jun 2020
        • 5
        #17
        Re: Bizhub C253 Magenta/Black Stripes across the page

        To conclude this, I replaced the transfer belt unit and did a graduation adjust and it's working perfectly again.

        Thanks alot to everyone who helped! Highly appreciated.

          Comment

          • qbert69
            Service Manager

            1,000+ Posts
            • Mar 2013
            • 1152
            #18
            Re: Bizhub C253 Magenta/Black Stripes across the page

            Just a note for future reference...
            If the cleaning blade on the ITB have the "chatter" marks for more than one color and they're blurred, you can be darn sure the problem is occurring with the ITB cleaning section!!! One way to check is open the side door during mid-process image transfer to see if the "skid marks" are visible. Additionally to completely rule out that the transfer belt unit doesn't need to be replaced, is to take out the ITB unit, run a thin piece of mylar plastic under the silicone cleaning blade to dislodge any clumped toner or paper dust and re-powder the belt with some yellow toner dust. Even before you do this procedure, you will want to inspect the belt for any lines, divots or indentations. [emoji41][emoji1303]

            Sent from my SM-N950U1 using Tapatalk
            REACH FOR THE STARS!!!
            Konica Minolta Planetariums!
            https://www.konicaminolta.com/planet...gma/index.html

              Comment

              Previous 1 2 template Next
              Working...