If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The info in the KB you have indicated is correct: 1. Press the Utility/Counter button. 2. Select Check Details. 3. Enter the Service Mode. 4. Enter the Service passcode and press End.
5. Etc...
I never stated that the method in your post was wrong. If you look back at my post, you will see that I quoted the incorrect method from another post, not yours. The info I originally quoted and replied to is wrong: "Choose the settings you like in scan mode then go into system settings->user settings->scan settings ->set current as default."
That method works perfectly fine on newer models, but on the 200, there was no such menus or settings.
Comment