Konica 654e (mono) SMB V2 with GDU-M0

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • jonbonse
    Senior Tech

    Site Contributor
    500+ Posts
    • Jun 2009
    • 730
    #1

    Konica 654e (mono) SMB V2 with GDU-M0

    Hi all

    I have a couple of 654e mono machines that need scan to folder setup scanning to Windows Server 2019...SMB V1 has been disabled on the server as expected and therefore uses SMB V2.
    Both machines have GDU-M0 firmware which was a recent update.

    Can anyone let me know if SMB V2 would work with this firmware or are there any special software switch settings I need to perform?

    Best wishes
    Tags: None
    • Synthohol
      Certified Konica Expert

      Site Contributor
      5,000+ Posts
      • Mar 2016
      • 5746
      #2
      ya need to lock 2.0 in with bit sw 219 i think? and in admin mode network smb 2.0 only maybe ntlm too, been a while.
      heres a doc from a helpful guy across the pond.
      SMB Version 2.0 Support-1.pdf

      sent you gdb_m1 but yours may be newer that incorporates this?
      not sure but this works.
      Attached Files
      We know a thing or two because we've seen a thing or two.
      The medication helps though...

        Comment

        • Duplicator
          IT Manager

          100+ Posts
          • May 2022
          • 245
          #3
          As long as the firmware is installed, function version is set to 7, and the SMB authentication setting is set to Kerberos/NTLM v1/v2 it will work.
          These settings work with newer versions of Windows:

          image.png
          Worked in IT for 12 years from Helpdesk up to System Administrator. Now working as the IT Manager at a copier company for the last 4 years.

          If I helped you out, please give me a thumbs up! It helps my reputation.
            👍 1

            Comment

            Previous template Next
            Working...