Konica Minolta c654e - fiery E100 undefinedresource error

[Outlander Kyle]

I installed the ic-414 fiery for this machine - figured out how to set up all the software and even successfully print from the E100 software.

However, I much prefer the Konica Minolta bizhub c654e PS software because certain options like offset printing from the finisher are not a part of the e100 driver.

When I set up the print driver with that software - my prints come out saying

ERROR:undefinedresource
OFFENDING COMMAND: findresource

STACK:
/ProcSet
/KMOptions
-dictionary-

anyone faced this and found a solution? other driver setups work normally, just feel limited. thanks.

[Synthohol]

the fiery driver will have all the options the emperon driver does afaik, is it setup correctly for LPR with Print as the queue name? enabled 2 way communication?
you shouldn't use the wrong driver. you can use the IP the fiery designated for the copier (usually 1 # up) and use the emperon ps driver and the fiery will passthrough the job to it but i dont recollect any finishing options that were not in both drivers.
fwiw on the fiery webpage there is a tab for downloads. i usually grab that and extract the drivers and manually install it LPR.

[Outlander Kyle]

This made me question my set-up entirely and helped me figure it out. tysm

I was not setting up the driver correctly. Add printer from the IP address window in the settings, put in that printer ip (mine was a few numbers higher than the driver. found on configuration sheet) protocol LPD selected - looks good to me now

TYSM!

[copyman]

Another happy customer thanks to this forum Fiery expert Synthohol. Good job Bud!

Perhaps Outlander will consider a small contribution to this website to help keep the lights on

[Outlander Kyle]

Sure thing. this forum is the best.

[copyman]

Sure thing. this forum is the best.

Thanks for becoming a contributor