1050pro

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • apump
    Trusted Tech

    100+ Posts
    • Mar 2009
    • 160

    #1

    1050pro

    I have one with 20mil that shifting the image to the rear about 1/4 of an inch I have changed out reg ass'y and even the ADu ass'y. I changed out the board (image process?)with HDD attached to it with another copier and the problem followed. that was about 2 months ago now the problem is back any ideas. I have the board ordered.
  • Si@danwood
    Trusted Tech

    100+ Posts
    • Mar 2008
    • 154

    #2
    make sure that the feed tray side guides haven't come out of "synch".I am not talking about the size adjustment, but the relationship between the front and rear guides.These can be corrected by lining up the arrows on the cam wheel under the feed tray itself.I have seen this cause image shift whilst on a run..Si

    Comment

    • apump
      Trusted Tech

      100+ Posts
      • Mar 2009
      • 160

      #3
      1050

      it does it from tray 3,4,5 they very rarely use tray 1,2

      Comment

      • JackofallCopiers

        #4
        Is this the first time changing the reg rollers? Were the loop adjustments changed before to compensate for the wear on the reg roller and now you put in a new roller which has a larger rolling radius.

        When you say shifting to the rear you do mean to the rear of the m/c not towards the exit side.

        Comment

        • simon

          #5
          there are two thin copper plates on the underside of the adu
          make sure that these are both in the same postion (1 isn,t bent up more than the other) these push the adu lower section up when you slide the adu back in on the rails

          Comment

          • apump
            Trusted Tech

            100+ Posts
            • Mar 2009
            • 160

            #6
            1050

            It shifts the image towards the rear of the copier. I'll be going out there later this week prob. Friday

            Comment

            • Gerg?
              Technician

              50+ Posts
              • Jul 2008
              • 67

              #7
              I had problem with registration, but it made jam same time. I changed lot things, but surprisingly the transfer corona was the guilty. If you have corona try it maybe you can save time.

              Gerő

              Comment

              Working...