Bizhub c6500e doesent accept fs-607 finisher

[Bogdan1306]

[Synthohol]

Re: Bizhub c6500e doesent accept fs-607 finisher

just to clarify, a Bizhub Pro C6500 right?
there is no e at the end correct?
if so yes an FS-607 is compatible with the Bizhub Pro C6500.

[Bogdan1306]

Re: Bizhub c6500e doesent accept fs-607 finisher

Nope Bizhub pro c6500E

[Synthohol]

Re: Bizhub c6500e doesent accept fs-607 finisher

i just realized im only considering US market, i forgot other countries have extra numbers or letters sometimes.
if the finisher is popping icp fuses maybe something shorted?
when i was brave, id unplug all connectors from the FCB and plug them in one at a time till i found a sparker and trace the short.
you can also use an ohm meter on the connectors and make sure the pinouts for ground are the only ones showing resistance with the frame.
if you find one that was supposed to be 24+ and the meter beeps then remove one connector at a time until there is no resistance and inspect that circuit.

[Bogdan1306]

Re: Bizhub c6500e doesent accept fs-607 finisher

i just realized im only considering US market, i forgot other countries have extra numbers or letters sometimes.
if the finisher is popping icp fuses maybe something shorted?
when i was brave, id unplug all connectors from the FCB and plug them in one at a time till i found a sparker and trace the short.
you can also use an ohm meter on the connectors and make sure the pinouts for ground are the only ones showing resistance with the frame.
if you find one that was supposed to be 24+ and the meter beeps then remove one connector at a time until there is no resistance and inspect that circuit.

So i inspected all the Signal cables, And all the voltage cables, all are Ok, the finisher recive power But the printer doesent see the finisher. What i dont do right?

[Synthohol]

Re: Bizhub c6500e doesent accept fs-607 finisher

hopefully this is a good hunch, that finisher has a stacker in it right?
unplug the stacker wires from the frame connector and see if the error goes away.
i cannot find the fs607 install instructions as i lost my access a year+ ago.

[Bogdan1306]

Re: Bizhub c6500e doesent accept fs-607 finisher

What stacker? Is only the booklet finisher with post inserter.

[Synthohol]

Re: Bizhub c6500e doesent accept fs-607 finisher

the stacker is the booklet part.
when you slide out the stacker, follow the arm in the back of it to find the connectors.
finisher may work independently so i was just trying to isolate the problem from the normal finisher part vs the stacker and its circuitry.