If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
When the EM signal (separate_em) is detected 3 times at the specified intervals, this phenomenon occurs 5 times in 1 job. The main body stops immediately, and the RL1 (Main) turn OFF.
Separation corona
HV (High voltage power)
CB (Main body control board)
Yup, go with what the prior poster said, either the block and insulators on the door or the trans sep unit itself. Been there, done that!
Comment