Bizhub C450 with Finisher FS 603: Finisher causes jams

siradlib

Technician

Join Date: Jun 2008

Posts: 23
#1

[Jamming] Bizhub C450 with Finisher FS 603: Finisher causes jams

06-22-2010, 10:06 AM

2010-06-22_09-41-01&.jpg

Does anyone have an idea what can be wrong here?

Last edited by siradlib; 06-22-2010, 10:36 AM.
Tags: 603, bizhub, bizhub c450, c45, c450, cases, config, displayed, errors, finisher, jam, jams, konica, konica minolta, malfunction, minolta, motor, paper, rear, service, service tech, tech, time, transport, wheel, wrong
siradlib

Technician

Join Date: Jun 2008

Posts: 23
#2

07-21-2010, 08:48 AM

To give a solution to my own thread:
In this case the finisher motor was changed. However, while reconnecting the new motor the tech apparently squeezed too much: One pin inside the connection jack (connection between stepper motor and logic board) was twisted!
Comment

[Jamming] Bizhub C450 with Finisher FS 603: Finisher causes jams