If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have been getting three black dots on my prints from my Konica CF3102 any ideas.
Every copy? Every 4th or 5th copy?
Check drum, fuser, and tbelt.
Color is not 4 times harder... it's 65,000 times harder. They call it "TECH MODE" for a reason. I have manual's and firmware for ya, course... you are going to have to earn it.
They call it "TECH MODE" for a reason. I have manual's and firmware for ya, course... you are going to have to earn it.
Comment