Konica 7035

[stevee104]

I have a machine that has shaft assembly that drives the fuser unit that has wore it self down along with the bushing egging out.In the parts book on page 14 the driving unit the shaft is gray out with no part number, can anyone tell me for sure that the part is not made, it goes with gear 31 and gear 22 on parts page 14.

[kingarthur]

Re: Konica 7035

if you have access to the "infohub", lookin the "ocp"....it has 2 part numbers for that part, the old part is 26na15140, which has a "holder" at each end p/no 46607602, the new p/no is 40la15140 which has a "bearing" at each end p/no 26na1728. its under parts modification number KOM090119...

[stevee104]

Re: Konica 7035

No we are not a konica dealer so all i have is a service and parts manual.
The new part number you posted 40la15140 is this the right number i just notice a l after the 0.

thanks

[kingarthur]

Re: Konica 7035

yes it is an "L"...if you have the bushings...then it seems it's the old part number, or else i'd order the bearings as well...just to be on the safe side

[stevee104]

Re: Konica 7035

So i am going to order the new part number 40la15140 , and this does not come with the new bearings so
i will have to order to new ones is this correct. Didn't know if this was a kit or not.

[stevee104]

Re: Konica 7035

Is the part number for the bearing right , my supplier said it was invalided number.

[ni311]

Re: Konica 7035

The code is correct:

40LA15140 - FIXING INPUT SHAFT ~ 2 Euro

[stevee104]

Re: Konica 7035

Can you me a pdf of the bulliten so i can get the part number for the bearings.

[CraigW]

Re: Konica 7035

These are what we stock...they are for the early models (with bushing) before they went to a bearing.

26NA15140 Fixing Input Shaft

466076020 Paper Feed Shaft Holder (bushing)

If it is the type with a bushing you have to stay with a bushing as the bearing would not fit the frame opening.