NOTHING BUT PROBLEMS AFTER INSTALLING 200K MAINTENANCE KIT. Help needed!

[Motchedo]

I have a Konica Colorforce 8050 was well overdue on its 200K maintenance. The copier worked fine with the occassional paper jam and such until now. I installed the new rollers, drum cartridges, transfer belt and developer. I have performed the required Automatic Developer Charge in the 36 Mode followed by the L Detect Initial Automatic Adjustment which all passed. Now I am trying to perform the Automatic Gamma Adjust and keep getting the error codes SC29-07 and SC29-08. When I run the Auto color registration adjustment, I keep getting the error 2 code.

Can you steer me in the right direction? I have swapped almost everything out with new parts and am stumped. Are there any electrical checks that I can perform?

[Albonline]

Re: NOTHING BUT PROBLEMS AFTER INSTALLING 200K MAINTENANCE KIT. Help needed!

take a good look at the transfer belt. think you may have assembled it incorrectly.

[JustManuals]

Re: NOTHING BUT PROBLEMS AFTER INSTALLING 200K MAINTENANCE KIT. Help needed!

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from

Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads

Paul@justmanuals.com

[RRodgers]

Re: NOTHING BUT PROBLEMS AFTER INSTALLING 200K MAINTENANCE KIT. Help needed!

take a good look at the transfer belt. think you may have assembled it incorrectly.

Yep