BizHub C451, transfer belt message

[copyman]

Machine is locked out with the message "replace transfer belt soon". I have tried a new belt, cleaned contacts. Cleared data.
Fuse does not blow on new belt unit.
I was told to check fuse ICP 23 on PRCB, it is good. Any help greatly appreciated. Thank You

[PeterG]

Re: BizHub C451, transfer belt message

Any P- Codes.? Oil can on display?

[copyman]

Re: BizHub C451, transfer belt message

No P-codes or oil can. I can get into tech rep mode but it doesn't show any codes. Thanks

[PeterG]

Re: BizHub C451, transfer belt message

Have you checked the continuity of the fuse? Just stick a multimeter on the external contacts of the belt.

[copyman]

Re: BizHub C451, transfer belt message

Yes fuse is good on new belt. Checked with meter several times during this ongoing troubleshooting process. Thanks

[MAD0RAM]

Re: BizHub C451, transfer belt message

Did you fuse the belt or put a new fuse in the old belt.

If you fused the belt make sure it was the correct fuse.

[copyman]

Re: BizHub C451, transfer belt message

Brand new transfer belt. Thanks

[emujo]

Re: BizHub C451, transfer belt message

If you've put a new x-fer belt in and the counters did not reset, then you have a bad printer control board...the alternative is to install the PPLM/IU mod..this will let the x-fer belt run until failure...Emujo

[JustManuals]

Re: BizHub C451, transfer belt message

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[dave-in-ards]

Re: BizHub C451, transfer belt message

If you've put a new x-fer belt in and the counters did not reset, then you have a bad printer control board...the alternative is to install the PPLM/IU mod..this will let the x-fer belt run until failure...Emujo

Hi, what is the ( PPLM/IU mod )
Thanks
Dave

[copyman]

Re: BizHub C451, transfer belt message

Not sure what emujo meant by PPLM/IU mod but I solved this issue by updating with special firmware

[methogod]

Re: BizHub C451, transfer belt message

had this happen before when not turning off main power when changing transfer belt. (i recommend unplugging machine)....