Looks like eco mode however when enabled on printer there is a difference but not on copy mode. Replaced CCD/CIS almost all PWBs except Power Supply. Problem fixed running U21(memory clear.)
-
-
Re: 300ci light on copies, prints OK
have you run a detailed gray adjustment?
Press the System Menu key.
2 Press [ ], [Adjustment/Maintenance], [ ] and
then [Next] of Gray Adjustment.
3 Press [Detail].
4 Press [Execute]. A color pattern is printed.
Check that the number "1" is printed at the bottom
of the color pattern.
5 As shown in the illustration, place the printed side
down on the platen with the three black boxes
aligned to the top.
6 Press [Execute]. The color pattern is read and
adjustment begins.
7 The second color pattern is printed.
Check that the number "2" (to "5") is printed at the
bottom of the color pattern and repeat steps 5 to 7
four times to read color patterns 2, 3, 4 and 5 in
sequence.
8 Press [OK] in the adjustment end confirmation
screen.
We know a thing or two because we've seen a thing or two.
The medication helps though... -
Re: 300ci light on copies, prints OK
Yes. Even went to recalibrating scanner using charts (U425) Nothing worked. Contacted Kyocera - pretty much recommended the steps already taken. Finally no other choice but to give U21 a go and it worked.Comment
-
Re: 300ci light on copies, prints OK
Well damn!
Hope you had all their settings saved.
Thats one to remember.We know a thing or two because we've seen a thing or two.
The medication helps though...Comment
Comment