TaskAlfa 1801 warming up in energy saver mode

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • White_Toner
    Technician

    50+ Posts
    • Aug 2009
    • 71
    #1

    TaskAlfa 1801 warming up in energy saver mode

    Hi to all!
    This machine goes to energy saver mode after copying
    or USB printing. No problem. Temperature of heat roller about 60C
    If customer print through network controller, machine prints staying
    in energy saver mode, but temperature of heat roller about 170C,
    Lamp flashing like machine is printing/ So, strong smell of plastic in office.
    All resets were made, timings e.t.c. I couldn't understand is it software
    problem (last version is on machine) or no.
    Situation is the same in different nets (3 of them)- machine is the same :-)

    reports are here http://www.mediafire.com/download/vl...801_report.pdf
    Last edited by White_Toner; 09-18-2016, 11:26 AM.
    Tags: None
    • blackcat4866
      Master Of The Obvious

      Site Contributor
      10,000+ Posts
      • Jul 2007
      • 22973
      #2
      Re: TaskAlfa 1801 warming up in energy saver mode

      Are you using the KX driver? It sounds to me like the print driver is continuing to send data, long after the print job is complete.

      I think I would use Deleter to remove all traces of the current driver, then re-load the KX driver. There may be other drivers sending to this IP address, so it may be beneficial to change IP addresses. =^..^=
      If you'd like a serious answer to your request:
      1) demonstrate that you've read the manual
      2) demonstrate that you made some attempt to fix it.
      3) if you're going to ask about jams include the jam code.
      4) if you're going to ask about an error code include the error code.
      5) You are the person onsite. Only you can make observations.

      blackcat: Master Of The Obvious =^..^=

        Comment

        • White_Toner
          Technician

          50+ Posts
          • Aug 2009
          • 71
          #3
          Re: TaskAlfa 1801 warming up in energy saver mode

          to BlackCat
          Different drivers and different nets - the same machine.
          New network card installed- no result/ Fuser warming up.
          If UI is active and you print using network, machine goes
          to energy saving mode correctly/

            Comment

            Previous template Next
            Working...